ATS "Hussar" V1

ApexTech Systems HUSSAR V1 is one manned combat jet build to destroy areal and ground targets, it is equiped with missile warning system, 2 small radars mounted to face front and back, 2 countermeasure launchers and toggled autogyro system. As for armaments it has 6 rocket hardpoints added with radar spear missiles in mind and 2 peeler rocket pods to engage ground targets. Double radar configuration allows to lock on targets behind you (as long as they are high enough). Once build with schematicannon it is ready to be assembled.

NOTE:

• Place schematic one block above ground before building.

• I used VS Eureka shiphelm to assemble it as physics entity, use other methods at your own risk.

• ALL SETUP STEPS MUST BE DONE AFTER ASSEMBLY (otherwise assembly process will brake all setups).

SETUP GUIDE:

1. Let schematicannon build it and assemble it with eureka shiphelm or your own method

2. Use trapdoors on both sides of cockpit behind control seat to get inside (sit in chair), leave chair, use Vehicular Wrench to RIGHT click Vehicle Control Node behind you and richt click control seat underneath you (Should say "Link Succesfull" every time) (Picture 4)

3. Leave cockpit (jump out or use trapdoor behind seat while shifting, shown in picture 4), go on top of a plane, open trapdoors on engines and toggle control trigger and with same wrench right click on jet turbines and said trigger. (Connecting engines and toggled autogyro) (Picture 1)

4. Connect (right click with vehicular wrench) all the control surfaces on wings and tail as well as airbrakes by the after burners (Picture 2)

5. Connect 2 countermeasures launchers by the tail (Picture 2)

6. Jump down, connect landing gears, 2 under engines behind rocket pods and one on the front under radar (Use vehicular screwdriver to right click set 2 landing gears under engines from 1 to 2, but you dont have to)

7. Connect all the rocket hardpoints and 2 control triggers as well as 2 radars, front and behind

8. Get yourself 2 fuel hoses, go on top to jet turbines, right click with one hose on one turbine, go under the plane and open fuel tank trapdoor to right click one of the red ones with same hose, should say Link succesfull, do the same to second one, remember you cant link 2 turbines to same fuel tank connection port (Pictures 1 and 3)

9. Get yourself vehicular screwdriver now and setup armaments your way or my way shown on picture 5

10. Climb on top again and set control surfaces on wings: right side (wing with Apextech logo) all to YAW -, left side all to YAW +, also set airbrakes to THROTTLE - (Picture 2)

11. This should be automatically upon built but just in case, tail: horizontal control surfaces all to PITCH +, vertical control surfaces all to ROLL + (Picture 2)

12. Lastly, set up countermeare launchers both to 0 and autogyro toggle control trigger to 1 (Pictures 1 and 2)

13. Under the plane where tail starts, behind gray aluminum trapdoor is a fuel input port (blue tank), fill it up with KEROSENE buckets (Picture 3)

14. Arm it up with your arsenal and off you go!

STEERING:

all by default, you can change keybinds by keybind setting in Valkyrien Warium

Throttle up/down - HOME/END

Roll +/- - C/Z

Pitch up/down - W/S

Yaw +/- - D/A

Landing gear - B

Radar cycle target - I

I recommend changing landing gear to =, roll +/- to PageDown/delete

Armament, countermeasures and autogyro are your designated numpad keys

Also Usefull:

throttle 2 to move, throttle 4 to take off, Throttle 5-7 for decent autopilot flight when autogyro is ON, throttle 10 afterburner for full speed (more speed slower the turns) throttle -1 or more - air brakes are ON slowing down aircraft greatly

KNOWN ISSUES:

• Report Issues in comments

ApexTech - Innovate Discover Conquer