max steam engine (aero, [ouroboros-400])

Initial Setup

Before starting the Ouroboros-400, make sure the entire system is set up correctly:

• Break and replace all Liquid Engines once to initialize them properly.

• Set the lava pump to flow toward the engine.

• Set both water pumps to flow toward the engine.

• Connect the two power chains on each side to their own corresponding generator.

Startup

Once the setup is complete:

1. Put a small amount of coal, wood, or another suitable fuel into the small startup engines.

2. Add the required initial lava to the two basins.

3. Start the startup engines and allow them to heat the system.

4. Once the lava-generation system reaches the required conditions, it will begin producing new lava.

5. The generated lava is automatically fed back into the system, while the remaining lava is stored and supplied to the main engine.

6. Once the main engine is running normally, the startup engines are no longer needed and can be stopped or removed.

After successful startup, the Ouroboros-200 can maintain its own water and lava supply and continue operating without continuous external fuel.