Racing hovercarft "Sea breeze" Mk1

You have to create "Drive by Wire" connections yourself, as they are not saved in the schematic:

• Controller Hub is in the cockpit behind pilot's seat. You can replace it with drive by wire typewriter if you want.

• Two directional gearshifts, that control propellers, can be found behind respective propeller bearings. Top face of each gearshift is "push forward". It can be accessed by looking underneath the horizontal symmetric sail stabilizer. Bottom face is "pull backward". It can be accessed through trapdoors on the bottom of hovercraft. To go forward you push with both propellers. To rotate left you push with right propeller and pull with left propeller.

• Redstone transmission controls power flow both to hovering fans and propellers. It can be accessed through central trapdoor on the bottom of hovecraft.

• Redstone accumulator located on the top of hovecraft can be used to gradually set redstone transmission output. Click it with the "Drive by Wire" cable, then click redstone transmission. Then create "Drive by Wire" connections from your controller hub or typewriter to rear and one of side faces of redstone accumulator to respectively increase and decrease it's signal (I use 'Space' on rear and 'Alt' for side face).