The R41 Raider

The explorer's choice of both cheap and effective air vehicle.
The R41 Raider is a top class, sleek helicopter that possesses 3 control propellers accompanied by a powerful back thruster that allows the most expert pilots to maneuver across nearly everything the Raider fits in.

Specs:
Maximum Altitude: y - 340
Speed: 75+ m/s
Body Dimensions: 5x5x16 (Not including propeller)
Weight: 80 kpg
Fuel Consumption: 3x Portable Engine, 1x Solid Fuel thruster.
Recommended Max Carrying Capacity: 72 kpg (y - 170 max height, est. full size 3x3x8 vault)
Armor Category: "Hey, there's a hole in my engine!" (Extra Light)
Weapons Systems: "What, am I supposed to use my hands?" (None)

Setup:
There are 3 portable engines, 2 right behind the cockpit seat and 1 right behind the gyroscopic propeller bearing and redstone transmission under a copycat trapdoor. Fill with fuel of choice (Blaze cakes STRONGLY recommended).
The solid fuel thruster's fuel intake is the barrel it is attached to. Fill with fuel of choice (Blaze cakes AGAIN recommended).
Using 5 Cables from Drive By Sable, connect the typewriter to the 3 inverted clutches inside the body, the docking connector, and the solid fuel thruster in the back.

Pilot's Notes:
Transmission-5: Hovers at y = 64 (provided no solid ground is below)
Transmission-8: Hovers at y = ~170
Transmission-15: Hovers at y = ~340

Beyond Transmission-10, using more than two control propellers (the ones controlled by inverted clutches) at the same time is no longer possible. Know what you are doing when up there pilots.

Using the side control propellers beyond 25 m/s becomes ineffective, turning into weak drift instead of proper turning.

Mods used in construction:
Create, Create Aeronautics, Sable

• Using this schematic without these mods is not possible. How are you even placing it?

Create Connected

• Using this schematic without this mod removes the inverted clutches, requiring a reconfiguration of internal systems to allow functional use of side and internal propellers.

Create Propulsion

• Using this schematic without this mod removes the solid fuel thruster and the redstone transmission under the main propeller, requiring the use of the analog transmission for the main propeller and a new propulsion source be added to the back. This will most likely weigh down the helicopter, reducing performance.

Tiny Redstone and Tiny Create

• Using this schematic without these mods removes the redstone panel located right next to the redstone transmission and the tiny link on top of the nixie tube. This will require redstone control be placed elsewhere on the helicopter, likely in the interior, in order to allow incremental use of the main propeller and readings on the nixie tube.

Copycats+

• Using this schematic without this mod removes all copycat blocks minus the singular copycat panel, thus ripping the helicopter's skin and flesh off. Do not do this. This also means you will have to replace them with full blocks, thus weighing down the helicopter.

Create Aeroworks

• Using this schematic without this mod removes the gyroscope located at the base of the tail. This removes some stabilization from the helicopter, but is one of the few mods I can safely say can be used without.

Drive By Sable

• Using this schematic without this mod removes the typewriter cable hub located in the cockpit. Without it, you can instead safely use a regular typewriter and use redstone links. Slight weight increase. But livable.