The Wall Runner

The Wall runner is a vehicle designed operate in extreme terrain such as mountain ranges or multi-leveled cities. The passenger section is attached to a servo that allows the section to be relatively level while the engine section moves with the tracks.

Controls:

Front console:

W/S: Control speed

A: Reverse

D: Docking Connector

Back Console:

A: turn on/off light

D: start engines

Setup:

1. Place in the contraption over a track of your choice and remove the red wool. do not rotate the model.

2. Open the hidden hatches located on top of the engine section and turn the red valve to unlock the passenger section. once unlocked, turn the valve the opposite direction to reset to passenger section's position.

3. use a Physics Assembler on the engine section and make sure it snaps on tracks below.

4. connect the Hose Connector to the adequate fuel source.

5. locate the Chain Connector which is hidden by trap door behind the support leg at the bottom of the vehicle. Connect the Chain connector to an external motor to begin pumping fuel into the vehicle's engines and fuel tank.

6. Once the engines are full, disconnect the Chain and Hose Connector and start the engine. Starting the engines while the Chain Connector is still attached can break the system.