Compact station for processing oil into diesel and gasoline

Instructions for starting the mechanism:

1. Run pipes from the pump unit to the bedrock and activate the bearing.

2. Set the mechanism in motion (for example, using a water wheel).

3. Place the burner with a blaze under the distillation tank closest to the pump unit and heat it with any block of wood.

4. After the engine starts, you can remove the previously installed rotation source and burner.

I recommend increasing the burners power by 450° from the initial setting by using the copper valve handle and rotating it 10 times at 45°. For your convenience, I installed shafts between the burners. Also, if you don't like the noise from the engine, you can install a muffler.