Neon Tetra - Suvival Ready Hover Bike

WARNING, MUST BE USED WITH COPYCATS+ AERONAUTICS WEIGHT MOD

https://www.curseforge.com/minecraft/mc-mods/copycats-aeronautics-weight

Welcome to the Neon Tetra, a survival ready, all electric Rocket Bike designed to skim across the oceans at break neck speeds.

Powered by an electric motor and two vector thrusters, the Neon Tetra can achieve speeds well exceeding 200m/s with a full throttle run time of over 100 real life minutes. The limit will be your chunk loading, not the Tetra.

Assembly

To use the Tetra, simply print the schematic without applying any rotation, grab the linked controller from the lectern (remove the lectern after), and assemble the contraption (also removing the assembler afterwards). The entire contraption is contained within one honey glue area, please apply the glue if it failed to print for you.

Controls and Usage

The tetra uses simple WASD controls using the provided linked controller.

The lever next to the seat controls the main power, this will engage the auto hover system and prevent power drain when parked.

A power limiter can be accessed via the top hatch, it limits your acceleration but not necessarily your reasonable top speed.

To recharge the vehicle, connect the front power connector to a generator, or simply attach a creative generator to the bottom of the accumulator (you may need to remove the contraption diagram)

Additional Notes and Debugging

If your Neon Tetra fails to take off after switching on power (i.e. the fans are sucking not pushing), simply switch the speed controller located at its bottom rear to Clock-Wise 256 RPM.

If your Neon Tetra is over-stressing, please make sure the electric motor is set to 64 RPM, it will over-stress if set lower and will only waste FE is set higher.

Due to issues with the hover behaviour of the fan nozzles, the Tetra may drift forward while idle. It is recommended to shut off the Tetra while parked, or tie it in place using the front rope connector.

Revision

1.3 - Replaced the New Age Connector with Crafts & Additions connector for charging due to sable connection incompatibility with the current New Age Connectors.