Small Helicopter

Hi, thanks for choosing my schematic.

To Start the Vehicle

1. Power on the two engines located behind the front seat.

       2. Take the linked controller and set frequencies according with               guide below, or make your own if you decide to change the                 frequencies. Check if everything linked properly before                         assembling the contraption. 

Controls

W = Forward (red wool)

A = Turn left (green wool)

D = Turn right (yellow wool) 

S = Backward (blue wool)

Space = Turn rotor on (orange wool)

lever = power/height (purple wool)

       3. Glue the contraption with honey glue and assemble it using                Physics Assembler

       4. Adjust the power lever located above the seat until the vehicle            is able to take off.

       5. The maximum signal strength should not exceed 12, and the               minimum is around 8.

       6. At higher signal strengths, the copter loses a lot of precision,              so I would not recommend trying to land it anywhere                          smaller than a field.

Specifications:

• Maximum altitude (signal strength 12): 272


• Maximum speed: 10 m/s 

Dependences:

-Create

-Create Aeronautics 

-Create Connected 

-Sable

-Copycats+  

Feel free to modify it to suit your needs.

Feedback is appreciated.

Have fun :)